Build Guide: Setting It Up At Your Range
Setting It Up, Bracing, and Staking It Down
After following all the previous instructions, it is now time to set up the rig in your shooting lane! To do this, you will use the remaining two full 10' lengths of conduit. These will be used to brace the rig upright. To do this, simply use the conduit along with a T connector attached to the top bar of the backstop. This connector should go between the edge of the backstop and the upright support for the touch frame. Then, attach another T connector near the other end of the conduit and drive one of the J stakes into the ground, hooking right above that T connector to prevent it from sliding.
My first iteration I had these extending backward in order to counter the arrow impact like this:
However, once I put up the popup tent, this meant that I needed a way to pass these supports through the backwall of the tent. This made it so I could not attach the back wall all of the way and this let more light in than I would like.
In order to make it as dark within the tent as possible (and frankly, it's easier to set up), I now recommend setting it up so the braces point forward. It is probably easiest to set up the popup tent first and then proceed to set up the rest of the rig inside of it.
As a final step, simply use the J stakes to stake the rig to the ground along the bottom of the backstop.
